Attention electrical contractors!! If you have ever wanted to own a wire tugger or some type of wire puller but were turned off by the cost well now is your chance to get your hands on a gamechanger when pulling long runs through conduit.
These types of portable wire tuggers from other companies usually start at around $4,000.00 & go up and usually only pull about 1000 lb. compared to this one which pulls 3000 lbs. This unit weighs less than 40lb which makes it easy to carry to jobs as needed for one person. This unit is in like-NEW condition and was only used on one job. You use your own 1.5" rigid conduit cut to whatever length is needed for your project and you can also put more than one piece of rigid pipe together with a coupling and reach heights well above 10 feet if that's what is needed. This is the only wire puller that I have found with this feature that does not cost north of $10K. Also, this wire puller comes with a Tri-Pod system that allows you to pull up from the floor through conduit feeds that are below your feet. You simply provide your own 1'' rigid pipe to make this work. This would also allow you to pull wires up through man-hole access as well.
This unit is very portable and powerful! Porta Pull’s ultra-compact design carries easily to the job site and sets up fast. The Apprentice Series 3000 offers a 1 HP Motor to give you 3000 lbs. of pulling Force. Pulls Cable from any Direction with its compact design & planetary gear design delivers smooth Power to the Capstan. 30% more pulling force than competitive models. Heavy-duty construction with a powder-coated tubular steel frame. Extends over 11 feet in length with your rigid conduit. Made entirely in the USA! Includes Apprentice Series 3000 # Cable Tugger with 1 HP self-contained drive motor. Universal front head assembly will fit 1” thru 4” electrical conduit. Remote foot switch and Right-angle sheave for operator safety. Extendable to 10 feet with 1.5” rigid pipe and pulls from any direction. Everything to make your next pull a lot easier! Wire Capacity 3 x 500 cables 450’ with 3–90-degree bends. 4 x 300 cables 450’ with 4–90-degree bends. 4 x 250 cables 550’ with 4–90-degree bends. Capacity 3000 lbs. Motor 1-Speed 8A-120 Volt Power 1 HP 746 Watts Pulling Speed No load-18 fpm Pulling Speed at Load 3000 lbs. 5 fpm Gearing 1-Stage Planetary Drive. Dimensions 24" L x 12" W x 5" D (Stored Size) Working Length 11 Feet Extended / Weight 39 lbs.
|
